Provisioning Yealink Devices

This article will provide a walkthrough on provisioning Yealink phones.

Updated at November 1st, 2026

Pre-Provisioning Steps

Before attempting to provision the desired phone, ensure that you have factory reset and updated firmware on the device and enabled MPP for the desired extension. 

For information on completing these tasks before provisioning the desired device, please see the following article:

Model Discrepancies

For Teams Based Phones

If you are using a Teams based phone, after provisioning, the phone will indicate that it is in Hybrid mode. This is set at the template level on the 1Stream side so that the phone can operate on all levels. 

The Yealink MP phone series does not support DSS key as BLF in hybrid mode. If you are wishing to have a phone that supports BLF keys, then it is recommended to use a Yealink non-Teams based phone. 

For Zoom Based Phones

If you are using a Zoom based phone, hybrid configuration is not supported at this time.

Provisioning the Phone Interface Directly

If you have phone device that is not compatible with the Managed Provisioning Portal, then please refer to our Manually Provisioning Yealink Phones article.

Unless the phone device is incompatible with the Managed Provisioning Portal, there will no need to log into the device and manually configure anything. 

Phone Still Not Provisioned?

If the phone has not provisioned with either sets of instructions, please refer to our Phone Provisioning Troubleshoot Guide.